lack of heat in the nozzles

Raspberry Pi Zero W

* Continue printing after power failure

På grund af gennemsigtigheden af ​​PLA kombineret med flagerne

TPM - Wash Solvent - 20L Adapter lack of heat in theWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 20 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs