Connectivity

Firmware can use the same configuration as RAMPS1

USB Stick with 8GB Memory

* 'Must Have' for you with 3D printer

TPM - Wash Solvent - 5L Craftbot - Reservedel ConnectivityWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 5 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs