In this case it's likely that you won't need as high a temperature as in Case 1

Coupler 5x5mm

Isolator for Ultimaker 2

- Turn off the power source and disconnect

MKS Gen 1.4 Simplify3D - Software In this case it's likelyMKS Gen 1. 4 mainboard Super nice board that works for most of the projects you could think of within 3dprint. Features: 1. The 2560 and ramps1. 4 collection on a board to solve the interfaces complicated, problem prone fault. 2. Replaceable motor drive, the drive supports 4988 and 8825 drives, TMC2100 drive. 3. Circuit board with high quality 4 layer, and made a special heat treatment optimization. 4. Using high quality MOSFET, better heat